Wahoo Cadance to PPV3

[BasJansenNL]

Can someone explain to me how I can pair the cadence sensor with the PowerPod V3. I have the speed and cadence sensor from Wahoo. en a wahoo Roam.

[Velocomp]

1) Make sure your cadence sensor is ANT+ (you should see the Ant logo on the side of the sensor)

2) Make sure your sensor is awake (spin the crank and look for non-zero cadence on your Wahoo)

3) Spin your speed wheel and make sure your Wahoo registers non-zero speed

4) After doing the above, press-hold your PP button for about 4 seconds, until it starts to flash green (pairing). Release the button. After about 30 seconds you should see PP light flash red 3 times (cadence sensor pairing), then solid green, then out.

5) After new sensor pairing you will need to do an out-and-back cal ride.

[BasJansenNL]

1) yes i bought as ant+

2) the sensor flashes blue

3) I first linked the PP and then I turned on the Wahoo Roam. HRM en Speed are oke but no Rpm

4) I did this but he doesn't see it.

5) i did

Velocomp_07_28_2020_2207_1_km_CalRide.ibr

(14.42 KiB) Downloaded 194 times

Velocomp_07_27_2020_1559_66_km.ibr

(340.74 KiB) Downloaded 188 times