Firmware 641 for PowerPod is available

Post Reply
Velocomp
Velocomp CEO
Posts: 5243
Joined: Fri Jan 11, 2008 9:43 am

Firmware 641 for PowerPod is available

Post by Velocomp » Thu Jul 26, 2018 1:22 pm

This firmware corrects bugs found in firmware 640.

* Whenever a sensor scan is performed (even to the same sensors) PowerPod is forced into a new, O&B calibration ride.
* Fixed a bug causing Isaac error message to appear when using the Device/Reset Profile command.

To obtain this firmware, connect your PowerPod to Isaac, then go to "Device/Check online for firmware update".

Make sure you do not touch your PowerPod or your computer during the firmware update.
John Hamann

Speedyg
Posts: 17
Joined: Thu Nov 30, 2017 5:35 am

Re: Firmware 641 for PowerPod is available

Post by Speedyg » Mon Aug 06, 2018 10:32 am

When PP is moved from one bike to another, which it has previously been paired with, does it default to a new scan for sensors and force an O&B cal, or does it just recognize the previously st up bike and go to that profile and we’re good to go?

Velocomp
Velocomp CEO
Posts: 5243
Joined: Fri Jan 11, 2008 9:43 am

Re: Firmware 641 for PowerPod is available

Post by Velocomp » Mon Aug 06, 2018 10:34 am

Speedyg wrote:
Mon Aug 06, 2018 10:32 am
When PP is moved from one bike to another, which it has previously been paired with, does it default to a new scan for sensors and force an O&B cal, or does it just recognize the previously st up bike and go to that profile and we’re good to go?
It recognizes the sensors from the previous bike, and you're good to go.

Sensor scan is ALWAYS started by an action of the user.
John Hamann

Post Reply