Hi John,
I recently upgraded to firmware v6.40 and, after having some issues with my bike profiles in Isaac, decided to do a hard reset of my PowerPod. I then reset all the profiles in Isaac and basically started again.
I then set up two new profiles in Isaac, one for my road bike and one for my TT bike. I then went through the sensor pairing process and shortened O&B calibration rides for each bike a couple of hours apart to avoid any possible cross sensor pairing problems. All seemed to go well.
The issue I have is that the profiles for each bike, notwithstanding I gave them different names, show up as "Unsaved (type: Initial Setup)" when I connect my PowerPod to Isaac. When I view the details of each "unsaved" profile, they are the same - both have the set-up details of my TT bike.
In view of the above, I'm not sure if the power readings for my road bike reflect the original details I inputted (i.e. riding on hoods, bent arms etc.) or are from the details of my TT bike (i.e. riding on aero bars etc.).
I've attached two ride files. The 07-17-2018 ride is for my TT bike and the 07-19-2018 ride is for my road bike.
Any guidance you can give me would be much appreciated.
Regards,
Nick Bean
Profiles and Calibration After Upgrade to Firmware v6.40
Profiles and Calibration After Upgrade to Firmware v6.40
- Attachments
-
- iBike_07_19_2018_1242_44_Miles.ibr
- (456.65 KiB) Downloaded 165 times
-
- iBike_07_17_2018_1916_10_Miles.ibr
- (84.79 KiB) Downloaded 185 times
Re: Profiles and Calibration After Upgrade to Firmware v6.40
We may have accidentally broken something in Isaac "Reset profiles" with the 640 release. We are investigating and will report back ASAP.
John Hamann