Powerpod/Garmin combo mount

Post Reply
GooseRider
Posts: 58
Joined: Wed May 10, 2017 10:52 am

Powerpod/Garmin combo mount

Post by GooseRider »

HI,

Have a question. Just mounted the Garmin/powerpod out front mount. When the letters on the powerpod is level so is the Garmin. I like tilting the Garmin up a little to make the display easier to read and avoid reflections. Is there any limit on how tilted the powerpod is? I want best accuracy.

Also, any preference for the ideal out-back cal ride? Hilly, no wind, some coast downs? Again my goal is best accuracy.

Thanks,

Morten
djaustin
Posts: 31
Joined: Sat Apr 23, 2016 3:52 pm

Re: Powerpod/Garmin combo mount

Post by djaustin »

Tilt should be less than 20 degrees. I calibrated mine with 11 laps of a closed one mile circuit, with the profile extracted from the ride using "check calibration". This changed the aero and wind scaling considerably, even compared with defaults in Isaac.
GooseRider
Posts: 58
Joined: Wed May 10, 2017 10:52 am

Re: Powerpod/Garmin combo mount

Post by GooseRider »

Thanks!!

You measure the 20 degrees based on the lettering on the powerpod, right?

Now if only I had a track like you describe ... ;)

Morten
djaustin
Posts: 31
Joined: Sat Apr 23, 2016 3:52 pm

Re: Powerpod/Garmin combo mount

Post by djaustin »

Yes, lettering horizontal is the neutral position. Any circuit will do. I used a 9.5 mile TT course to calibrate the TT bike. I raced it this morning with very consistent readings.
Post Reply