New Setup

[dgf]

Went with new bar set up and just no way the Newton was going to see clean air without using RWS. Did some pondering and came up with this setup:





Seems decently clean, simple, should see good air. Will try Cal Ride tomorrow.

[Velocomp]

Looks good! Please post a ride file!

[dgf]

Seems like it works OK. Maybe a little windy for a Cal Ride but data looks OK to me...??? Attached Cal Ride and little loop I did a couple times.

Used two of these for the set up - pretty simple:
http://www.amazon.com/Profile-Design-Un ... uter+mount

[Velocomp]

Seems like it works OK. Maybe a little windy for a Cal Ride but data looks OK to me...??? Attached Cal Ride and little loop I did a couple times.

Used two of these for the set up - pretty simple:
http://www.amazon.com/Profile-Design-Un ... uter+mount

Your cal ride looks great but your 13 mile ride is odd, for two reasons:

1) your CdA is different from your Cal Ride, and is set to road-bike value. Did you change it? If so, why

2) It looks like you have strong tail winds in part of your ride. Is this correct?