Bottom display shows CAL & HR - no cadence!

[aytchkay]

I woke up to 31 deg F! By the time I started my ride it was around 40 deg F. - Chicago skipped summer and Fall this year!

When starting out my iPro Gen 3, wireless, paired with HR-Cad-Spd. As I started riding, the bottom readout showed "CALories" , and nothing else!
When I got home, I went to setup and saw that there was only one item paired - it must have been Spd because I did get speed readouts.
I re-scanned and all 3 were paired. Started riding again, but only CAL and HR were indicated - NOT CADence.

How do I get CAD back?

[Velocomp]

Please confirm that your cadence magnet is passing very close to the notch in the cadence sensor--there should only be about a 1/8 inch gap.

Then, try your experiment again and see if you get cadence.

If not, remove the battery from your cadence sensor, put it in backward to hard-reset the sensor, then reinsert normally. Wave the magnet past the cadence sensor. WAIT ONE MINUTE, then try the Scan process again.

Let us know what you find.

[aytchkay]

It worked!!

thanks so much.....especially for your rapid response. Velocomp support is tops.

howard