AeroPod, PowerPod and Newton

I got the power pod lite and set up on my previous bike and all was good... Fast forward to today, after a crash 2 months ago, I tried to set it up on a new bike, this morning I took it for the 1st ride and did the calibration process, seemed good, I'm attaching the files generated.
The problem is that I used Isaac software and pushed the setup tab again, and now I think I need to do a second calibration... Is there a way to load the previous profile, and could you help me to check if this calibration was properly done?
thanks in advance
Alejandro

I used your 37km ride file to adjust profile.

Load the attached profile into your device and all will be well.

Corrected profile and ride file attached.

Thanks John!!
will upload and tomorrow will report

John I uploaded the profile you kindly sent to me and today I went our for a ride... do you think is all good now?
Thanks againg
Alejandro

alecs123 wrote: ↑Thu Aug 05, 2021 3:07 pm John I uploaded the profile you kindly sent to me and today I went our for a ride... do you think is all good now?
Thanks againg
Alejandro

Assuming there was a strong tailwind on your downhill descent, all is well.