AeroPod, PowerPod and Newton

Posted: **Mon Jun 29, 2015 12:31 pm**

Hi,

My wife bought me a set of Garmin Vector 2 pedals for my birthday and I would like to use them with my Newton 5+ Powerstroke.

Are these the current instructions for calibrating the devices to work together?

http://www.ibikesports.com/wp-content/u ... 13_red.pdf

I suspect perhaps not as page 13 cites tilt calibration, and I thought tilt calibration is obsolete in firmware 5.0+?

The calibration procedure for the Newton/WIRELESS DFPM combination is COMPLETELY DIFFERENT FROM TYPICAL NEWTON CALIBRATION PROCEDURE:
a. Tilt calibration and Cal Wind are the same
b. A single calibration ride, 4 miles long, IS REQUIRED
c. The 4-mile ride is analyzed in Isaac software (Tools/Check Calibration…)
d. Baseline (normal) aerodynamic and frictional drag coefficients are determined by the Newton/DFPM data

Thanks,
Don

Posted: **Sun Aug 09, 2015 8:37 pm**

Bump. Is the Garmin Vector 2 supported at all?

I know my Vector is outputting power as I can see power displayed on my 910XT watch. But when I scan for sensors on the Newton, it doesn't seem to find the DFPM.

Any suggestions?

Thanks,
Don

Posted: **Sun Aug 09, 2015 10:59 pm**

We will need to check this. ANT+ keeps changing their standards...

Posted: **Wed Aug 12, 2015 7:21 pm**

Thanks, John, I would appreciate it.

Regards,
Don

Posted: **Tue Aug 18, 2015 7:20 pm**

It looks like there is a new ANT+ protocol for the Garmin Vector 2. We haven't implemented this protocol in our FW.

AeroPod, PowerPod and Newton

Garmin Vector 2 / Newton 5+ Powerstroke calibration

Garmin Vector 2 / Newton 5+ Powerstroke calibration

Re: Garmin Vector 2 / Newton 5+ Powerstroke calibration

Re: Garmin Vector 2 / Newton 5+ Powerstroke calibration

Re: Garmin Vector 2 / Newton 5+ Powerstroke calibration

Re: Garmin Vector 2 / Newton 5+ Powerstroke calibration