Adjusting Parameters - Check Calibration
Posted: Wed May 17, 2023 10:22 am
John -
Isaac identifies 6 parameters that are used to establish the power during a ride.
Of the six, two are held and the remaining 4 are adjusted when checking the calibration. The variables held constant are selectable using the advanced options. When installed, Isaac has these set in a default configuration.
Which brings me to the questions about what variable are best to be held at the initial settings and why those?
Can you change the ones that are held constant and retry the check calibration - on the fly? So that one could see the impact on calibration by a variety of variable combinations? I think I have tried this without success, but I may not have been implementing this correctly.
Finally, what issues might lead to negative friction estimates (admittedly an unrealistic parameter.)
Thanks,
Tom
Isaac identifies 6 parameters that are used to establish the power during a ride.
Of the six, two are held and the remaining 4 are adjusted when checking the calibration. The variables held constant are selectable using the advanced options. When installed, Isaac has these set in a default configuration.
Which brings me to the questions about what variable are best to be held at the initial settings and why those?
Can you change the ones that are held constant and retry the check calibration - on the fly? So that one could see the impact on calibration by a variety of variable combinations? I think I have tried this without success, but I may not have been implementing this correctly.
Finally, what issues might lead to negative friction estimates (admittedly an unrealistic parameter.)
Thanks,
Tom