Search found 5 matches

by markrhill
Sat Sep 01, 2012 1:11 pm
Forum: Newton General Questions
Topic: Newton power output via Ant+
Replies: 3
Views: 4922

Re: Newton power output via Ant+

Filt set to 0, so I guess the problem must be somewhere else.
by markrhill
Fri Aug 31, 2012 3:03 pm
Forum: Newton General Questions
Topic: Newton power output via Ant+
Replies: 3
Views: 4922

Newton power output via Ant+

I've recently started to use the Sportiiiis heads up display to track power during intense intervals. This is a small unit that attaches to your glasses, and places a bar of LEDs at the bottom of your field of vision, which show red/yellow/green to indicate where you are in user-defined power zones....
by markrhill
Mon Jul 16, 2012 5:06 pm
Forum: Newton Setup
Topic: Wind cal ?
Replies: 7
Views: 6521

Re: Wind cal ?

While I like the Newton in general, I've had a couple of rides where the wind cam was totally off: during the ride the watts looked too good to be true, and when I downloaded I saw a false ~5mph headwind when conditions were actually calm. Weird part is the problem is intermittent: most of the time ...
by markrhill
Wed Dec 29, 2010 11:37 am
Forum: iBike Dash Setup
Topic: iDash wind reading error
Replies: 5
Views: 5335

iDash wind reading error

After a week of outstanding performance, I had a problem this morning with bogus wind readings. The first attached file showed a ~17mph tail wind, which certainly wasn't the case. I pulled over, found the "Zero wind" setting, and then recorded the 2nd file, which showed a ~15mph tail wind ...
by markrhill
Sun May 02, 2010 12:49 pm
Forum: Gen III troubleshooting
Topic: Zero Length File error
Replies: 13
Views: 61184

Re: Zero Length File error

Had this error yesterday and found another source: I had plugged the iBike into a USB hub, vs. directly into USB port on my computer. Tried all the other suggestions, no luck. When I plugged directly into the computer, files appeared no problem. Recommend that you add a warning in the std docs recom...