Big list of thoughts and questions that are hopefully helpful to others as well.
1) Issac does not default to Profile 4 when I launch it, connect my AP, and select Device/Set Up Device. This is on the installed Issac software that I have used for a few years with my old PP. Which begs the question, should I reinstall Isaac and start clean with AP? The install I have is version 4.1.1
2) On my road bike I have machined a custom aluminum mount for a number of reasons. I wanted the AP a bit lower and centered for aerodynamic reasons. Also, I ride my road bike a lot in a pseudo-aero position. When the AP is mounted in either a bar, stem or front mount, my hands hang in front of the pitot tube. I had this problem with the PP and I'm not sure if I have solved yet. I've attached a few pics to clarify.
Some questions:
1) How stiff is stiff? If I push down on my mount at the AP location pretty hard it deflects maybe a mm at the most.
2) What's a good downward angle for the pitot tube. Mine is -1.4 degrees.
3) Regarding the hanging pseudo-aero hand position. Can you give me some guidelines for what will be problematic. Also could I extend the pitot tube to get out in front of my hands.
- APmountCrop.jpg (90.28 KiB) Viewed 2674 times