AeroPod, PowerPod and Newton • Power Pod V3 Low reading

Page 1 of 1

Power Pod V3 Low reading

Posted: Tue Feb 14, 2023 1:29 pm

by Dalibor

John hi,

I'm using V3 for quite some time, and I'm pretty happy with it. Recently, I changed the bike, made some tweaking on my profile, and did the calibration ride. Everything went well, but afterwards I had noticed low reading on my power output.
I did a test ride against my Assioma Duo, and my suspicions was confirmed. Powerpod readings are some 20% lover then my Assioma's.
Could you be so kind, and take a look on my ibr and tcx files of the same ride, and tweak my profile so they match?

Thank you very much!
BR,
Dalibor

Re: Power Pod V3 Low reading

Posted: Tue Feb 14, 2023 7:09 pm

by Velocomp

Here is what I did:

1) I merged your .tcx file into your PP file. This merges your Assioma data into your PP ride file

: Screen Shot 2023-02-14 at 6.59.00 PM.png (205.58 KiB) Viewed 833 times

2) I used the command "Check Calibration" to check the DFPM data against your ride file

: Screen Shot 2023-02-14 at 7.00.48 PM.png (41.83 KiB) Viewed 833 times

: Screen Shot 2023-02-14 at 7.02.34 PM.png (21.04 KiB) Viewed 833 times

3) I used the DFPM data to adjust your profile

: Screen Shot 2023-02-14 at 7.03.05 PM.png (53.29 KiB) Viewed 833 times

4). This change improved your wind scaling and increased your watts

: Screen Shot 2023-02-14 at 7.04.00 PM.png (229.77 KiB) Viewed 833 times

Corrected ride file and profile are attached

Re: Power Pod V3 Low reading

Posted: Wed Feb 15, 2023 2:27 am

by Dalibor

John hi,

thx for the instructions & corrections to the profile!

Br,

Dalibor