AeroPod, PowerPod and Newton

hello,

today I wanted to install my powerpod on my second bike. However I couldn't get it calibrated. When the powerpod reaches 25 it goes back to 0 and the green and red light are flashing.. After 15 attemps I stopped: Can you help me out because it is very annoying:

Thanks

kurt

Sorry for your frustration...

When your PP flashes red/green, it is ready to begin a calibration ride. You then have to click the button to cause it to actually start the cal ride. When you click the button the light will flash yellow and watts will slowly climb to 50 as you ride. At 50 the light will turn solid red and the number will "stick" at 50. Slow down to a near stop, then turn around to ride back. Watts will climb to 100, at which point calibration is complete.