AeroPod, PowerPod and Newton

I have 2 profiles set up using profile 1 and profile 3. Here's what the Isaac screen for Set Active Profile in Device looks like.

1: Cube extracted on 16/08/2020 Prof '1
2: Unsaved (type Initial Setup
3: Forme exForme Tweaked 23/12/201
4: Unsaved (type: O&B Tweak

Profile 1 has been working ok all summer and now I want to use profile 3 which worked ok earlier in the year.

When I set profile 3 as active it works and sends readings to my Garmin computer but if I stop my bike the Powerpod reverts to profile 1.

I have tried changing the profile from 1 to 3 on a few occasions but get the same problem each time.

Has anyone got any ideas?

Are you using the same sensors on both bikes?

Please extract your profiles using Isaac, and post them here.

No John, different sensors on each bike.

The Cube works fine, it's the Forme that drops out.

Here is my last Cube ride and the Forme bike ride until I stopped and it then dropped out.3

Thanks.

Yes, you have different wireless IDs, which is good.

Question: when you stop riding and then resume, how do you know your device reverts to a different profile?

It was an assumption really because there was no power readout to my to my Garmin when I resumed the ride after a 5 minute stop. When I got home and plugged it into Isaac it showed profile 1 active rather than profile 3.

Profile 1 still works on my Cube bike so how about me deleting profile 3 from Powerpod, reloading it and doing an out & back ride on my Forme bike using profile 3?

Don't take any further action at the moment John - I''m trying another permutation of setting profile and doing a ride.
I'll report back.