Page 1 of 1
Wind cal incorrect
Posted: Tue Jun 09, 2020 9:58 pm
by cbuchan
I went on a ride in the rain and at one point the wind sensor seemed to stop working. No problem I kind of expected it wouldn't work in the rain but today I went out and my file shows that I had a massive tail wind the whole time as though the wind sensor is not working. Is there a way to check if the sensor is working correctly.
The first file is my ride from today wind was fairly calm about 5-7 miles per hour from the west.
The second was an out and back.
Re: Wind cal incorrect
Posted: Wed Jun 10, 2020 11:16 am
by Velocomp
Make sure there is no residual water in the wind port or in the baro sensor port (on the side of the unit).
If you see water blow it out. Things should then be OK.
Re: Wind cal incorrect
Posted: Thu Jun 11, 2020 10:36 pm
by cbuchan
I checked the ports(wind on the front and baro on the bottom). Todays ride still had the same problem. Is there something I can do to check the ports better.
the 6-09 ride and today (attached) were in dry warm conditions and the PP is stored indoors between rides.
Re: Wind cal incorrect
Posted: Thu Jun 11, 2020 10:37 pm
by cbuchan
Sorry missed the attached file.
Re: Wind cal incorrect
Posted: Fri Jun 12, 2020 5:55 am
by Velocomp
cbuchan wrote: ↑Thu Jun 11, 2020 10:37 pm
Sorry missed the attached file.
Something is wrong. Please email
technicalsupport@velocomp.com for next steps.