John-
Could you please take a look at this ride. This is my fat bike (2 hour race) I have been trying to get this setup on the fat bike for a couple months and had started by using some Crr figures found throughout this forum but whenever I did that, this PP would go into an infinite loop when trying do a cal ride- meaning the cal ride would complete, then about 10 seconds later it (10 seconds of working power data) it would enter cal ride again. This happened over and over.
Finally I just reset and did a plain cal ride without tweaking any values and have been using that. The wind on this ride file seems wrong though. All behind me?? Don't think so.
Please see what you think.
I actually attached the last two races I have done.
thx
Fat Bike check please
Fat Bike check please
- Attachments
-
- iBike_02_08_2020_1150_23_Miles_HiDef.ibr
- (987.43 KiB) Downloaded 165 times
-
- iBike_02_22_2020_1121_23_Miles_HiDef.ibr
- (1.19 MiB) Downloaded 159 times
Re: Fat Bike check please
Your wind readings are wrong. Please email technicalsupport@velocomp.com for next steps.
John Hamann