AeroPod, PowerPod and Newton

I am also stuck in in a cal loop. i have done several out and back rides and it always restarts a new cal ride 0 to 100 right after. can someone take a look at the attached files and see if there is something wrong?

Sorry to say this, but you have a wind sensor problem.

Please contact technicalsupport@velocomp.com Tom will tell you what to do next.

Ok thanks for letting me know, it is a relief to know it is not my fault. I have been struggling with calibration for 2 weeks, but I haven't had time to try multiple cals in a row until yesterday to be sure there was an issue.

timp wrote: ↑Fri Dec 20, 2019 8:45 am Ok thanks for letting me know, it is a relief to know it is not my fault. I have been struggling with calibration for 2 weeks, but I haven't had time to try multiple cals in a row until yesterday to be sure there was an issue.

Yikes! Setup should be easy and fast...if you're having problems, the sooner you let us know the sooner we can help...

I also have this problem. Is this because I stop during the 0-50 watt calibration?

Sydney Go wrote: ↑Fri Dec 20, 2019 9:39 pm I also have this problem. Is this because I stop during the 0-50 watt calibration?

It is impossible to tell what your issue is. Please post a ride file, or describe in more detail what happens. The person who started this thread had a problem with his wind sensor...there are other reasons the "Stuck" problem might occur.