AeroPod, PowerPod and Newton

I can not make a setting on PP who giving realistic datas about power on my MTB. I have power meter on my TAX trainer and also have direct power meter on my road bike this two has very similar datas about my FTP etc… I also comparate before last two calibration O&B ride Iin attachment) power with my friend, when we rode together one day , he has direct Garmin two pedal PM, the same kilogram and we had big different in measuring. Approximately 15-20% my PowerPod shower less than this. If I compare with Strava again it is more less.
I have setting PP according the recommendation for MTB CdA=0.49 , Crr=0.0086 , total weight is 92kg. After that I did calibration ride few times and everything was very similar not realistic results .
Please find attachment in this and next message
First O&B ride is only to 50% and back, and after that I have normal ride.
Second O&B ride I did on the same ride because I didn't was satis-fate but this was from 0-50 and back 50-100, after that when device started measuring i did one more time same track like O&B because comparattion , for you.
Las three files is my normal ride after second calibration, maybe this can help you to find where is the problem.
I point out that the PP is properly mounted on the original carrier (holder) and the cables do not interfere.
Please help me to setup this device correct , this data now make confusion on my Garmin devices about my fitness…..
I tied PP on my road bike earlier and the results was very realistic. My wishes is use this device for all of my bikes

Plus two riding file

Your problem is that you are not completing a calibration ride. Either your PP is improperly mounted (likely pointing too high in the air), or something else is not going properly during the ride.

I corrected your profile with the Check Calibration command. Corrected ride 3 file attached.

Load the attached profile into your PP and you should get much better readings. You may still need to adjust this profile for correct weight

Ok, but there is two files. Should I upload Dusan.ibp or DusanRide3corr.ibr ?
There is pictures, tell me what I must correct.
I finished O&B ride and PP started measuring. What I should do next time I have 3 bike and want use for all of this PP

I uploaded ibp in my profile settings it seems that everything is uploaded. There is all sensors record an the rider weight, bike weight ....but now is different Aero , fric etc....I also uploaded ride 3 and this ride looking like a my usually ride. Tomorrow I will try on the ride. Next step should be my Cyclo Cross bike and Road bike ...

The letters on the PP are horizontal. is that all right?

Dusan Turkulov wrote: ↑Sat Aug 10, 2019 12:55 pm The letters on the PP are horizontal. is that all right?

Yes, the horizontal orientation of your PP looks good.

Hello again. I had ride after correction ant now it looking much better. I had few strange situation, on the flat the power was sometimes on my opinion too high and on up to hill less than normal. You can see this situation between 18 and 24 km. You can see also this on my HR..... power was less then a flat and HR was higher

Your ride file looks MUCH better!

What's going on in the section you reference is the effect of your front fork not being locked up.

When you descend your PP adjusts itself for the changed angle happening during descent. When you hit the flats, the fork compression and position changes, and it takes a few minutes for PP to readjust itself for the changed fork position. This is normal.

OK. That seems logical