Page 1 of 1
calibration ride
Posted: Wed Jul 03, 2019 1:47 pm
by istvan
Hi,
this is my calibration ride. I'd like to know it is ok, or I have to do another one. Thanks a lot!
Re: calibration ride
Posted: Wed Jul 03, 2019 2:59 pm
by Velocomp
Looks good!
Re: calibration ride
Posted: Wed Jul 03, 2019 3:04 pm
by istvan
Thanks
.
Re: calibration ride
Posted: Thu Jul 18, 2019 11:32 pm
by kennyliu10
Can someone please also check mine? (just got my PPv3)
I got a feeling it's a little on the low side. This is my own calibration ride/file. I tried to use the analyst feature on Isaac but it says it need to be a longer ride, why is that? There are different version of calibration rides? (short and long)? I followed the instruction for the calibration ride, and i turn around at 50w and it's not as long as Isaac required to perform analyst.
Also, can the PPv3 auto calibrate the more i ride with it?
Thanks,
Re: calibration ride
Posted: Fri Jul 19, 2019 6:08 am
by Velocomp
kennyliu10 wrote: ↑Thu Jul 18, 2019 11:32 pm
Can someone please also check mine? (just got my PPv3)
I got a feeling it's a little on the low side. This is my own calibration ride/file. I tried to use the analyst feature on Isaac but it says it need to be a longer ride, why is that? There are different version of calibration rides? (short and long)? I followed the instruction for the calibration ride, and i turn around at 50w and it's not as long as Isaac required to perform analyst.
Also, can the PPv3 auto calibrate the more i ride with it?
Thanks,
This is the internal cal ride. Its data does not useful for analysis. If you kept riding after the cal ride, please post that ride. The subsequent ride will have useful information.
Also, do a hard reset of your device. Press-hold the button for about 12 seconds. The light will go out briefly then turn back on. Release the button. Do a 10 minute ride after this.