New PP user - first questions (updated)
Posted: Sat Jun 22, 2019 4:06 am
Hi,
just bought a ANT+/BLE PP and tried out&back calibration yesterday
FW is updated to 6.41
My ride yesterday was Out&back calibration, where led status behaved as it should in all phases (calibration ok) followed by an 8 km ride just after that, to see how power was behaving on my PP
I read in firmware update notes that from FW 6.40 the Out&back calibration part of the ride is not recorded
So, when I used Isaac to check calibration after my ride, why did it ask me to highlight the Out&back part of my ride?? I could not find it.
Also, I saw some of your video tutorials on youtube, in particular one saying that white line (speed) should always be higher or equal to blue areas (wind)
In my ride yesterday I had some wind coming back, nothing particularly strong but it is shown in the file.
Is my calibration ok?
I was thinking to do another calibration today where I would only do the Out&back ride.
Will it be shown and downloaded or if I stop my ride when I get to 100% and see real power values, no file will be shown in Isaac?
In other words, should one always do a ride right AFTER Out&back calibration to have that ride recorded and to be able to analyze calibration with Isaac?
In that case, should that other ride start and end in the same point, as an
Out&back calibration ride?
(I’m asking this because Isaac kept asking me if my ride ended where it had started, when I tried to analyze yesterday's ride)
Here is yesterday's ride, if you can check it and tell me if I need to re-calibrate
Thanks
just bought a ANT+/BLE PP and tried out&back calibration yesterday
FW is updated to 6.41
My ride yesterday was Out&back calibration, where led status behaved as it should in all phases (calibration ok) followed by an 8 km ride just after that, to see how power was behaving on my PP
I read in firmware update notes that from FW 6.40 the Out&back calibration part of the ride is not recorded
So, when I used Isaac to check calibration after my ride, why did it ask me to highlight the Out&back part of my ride?? I could not find it.
Also, I saw some of your video tutorials on youtube, in particular one saying that white line (speed) should always be higher or equal to blue areas (wind)
In my ride yesterday I had some wind coming back, nothing particularly strong but it is shown in the file.
Is my calibration ok?
I was thinking to do another calibration today where I would only do the Out&back ride.
Will it be shown and downloaded or if I stop my ride when I get to 100% and see real power values, no file will be shown in Isaac?
In other words, should one always do a ride right AFTER Out&back calibration to have that ride recorded and to be able to analyze calibration with Isaac?
In that case, should that other ride start and end in the same point, as an
Out&back calibration ride?
(I’m asking this because Isaac kept asking me if my ride ended where it had started, when I tried to analyze yesterday's ride)
Here is yesterday's ride, if you can check it and tell me if I need to re-calibrate
Thanks