Page 1 of 1
New power pod with rides on it
Posted: Wed May 29, 2019 8:02 pm
by ericpenn
Hello All. Just purchased a new power pod from Velocomp.com and it seems to already have a few rides on it's file. Is this common?.. I did a out and back cal ride and it was working good. The next day I went out to ride and the power pod numbers were all super low 30w 40w and never getting higher than 76w. Any help would be great. Thanks and have a great night.
Re: New power pod with rides on it
Posted: Thu May 30, 2019 10:30 am
by Velocomp
Please post your .ibr ride files.
Re: New power pod with rides on it
Posted: Thu May 30, 2019 2:53 pm
by ericpenn
Now when I push the activate button the power pod shows a red light and then goes out and does not read anything.
Re: New power pod with rides on it
Posted: Thu May 30, 2019 3:36 pm
by Velocomp
ericpenn wrote: ↑Thu May 30, 2019 2:53 pm
Now when I push the activate button the power pod shows a red light and then goes out and does not read anything.
Your 5/25 file is fine.
You have body weight as 154 lbs and bike 16 lbs. Is this correct? You appear to be riding a TT bike; is this correct?
It sounds like you reset your device, which would cause the red light to come on. Load the attached profile into your device and that should fix things.
Re: New power pod with rides on it
Posted: Thu May 30, 2019 6:15 pm
by ericpenn
Thank you for taking time to look at the file and helping me. Have a super day.