PP newbie help - calibration, interpreting Issac results
Posted: Mon Dec 31, 2018 7:50 pm
First attempt to use, calibrate a PowerPod ANT.
Garmin Edge 1000
New magnet-less Garmin speed and cadence sensors
Garmin HRM
Struggled a bit to understand how to properly setup the PP, review the O&B data, other results.
I first rode to what was considered an appropriate location, was eventually successful initiating the calibration process. I believe this is the first ibr file, which corresponds approximately to the 22 minute point in the attached fit file. Weather was less than ideal, I was a bit concerned that variable winds may have resulted in erroneous results, indicated by what appeared to be lower than expected power readings when climbing small inclines versus relatively flat sections.
I then decided to try again, in another area, believed to be better sheltered from the wind, which should be represented by the second ibr file. It took several attempts to properly initiate the calibration process; Garmin would start counting watts, return to zero after reaching 5; appeared to be resolved by pushing the PP button after the yellow LED changes to alternating red and green. I believe this corresponds to about the 54 minute point in the fit file. To my uneducated eye, without the full understanding of how to interpret the Issac data, the empirical perception from slope, cadence and HRM data do not seem to correlate properly with power, wind appears to have an excessive influence.
Attached are the only ibr files found on the PP, along with a zipped fit file from the Garmin Edge 1k.
I would be most grateful for any guidance, recommendations.
Garmin Edge 1000
New magnet-less Garmin speed and cadence sensors
Garmin HRM
Struggled a bit to understand how to properly setup the PP, review the O&B data, other results.
I first rode to what was considered an appropriate location, was eventually successful initiating the calibration process. I believe this is the first ibr file, which corresponds approximately to the 22 minute point in the attached fit file. Weather was less than ideal, I was a bit concerned that variable winds may have resulted in erroneous results, indicated by what appeared to be lower than expected power readings when climbing small inclines versus relatively flat sections.
I then decided to try again, in another area, believed to be better sheltered from the wind, which should be represented by the second ibr file. It took several attempts to properly initiate the calibration process; Garmin would start counting watts, return to zero after reaching 5; appeared to be resolved by pushing the PP button after the yellow LED changes to alternating red and green. I believe this corresponds to about the 54 minute point in the fit file. To my uneducated eye, without the full understanding of how to interpret the Issac data, the empirical perception from slope, cadence and HRM data do not seem to correlate properly with power, wind appears to have an excessive influence.
Attached are the only ibr files found on the PP, along with a zipped fit file from the Garmin Edge 1k.
I would be most grateful for any guidance, recommendations.