Hi,
My PP install with firmware 6.41.
a. 1st day - completed my O&B. I set the best accuracy and follow the steps as in the instruction.
b. 2nd day - I turn on PP and pairing is done. The problem here is PP in the O&B mode again although it was completed during my first ride.
Kindly advise.
Firmware 6.41
Re: Firmware 6.41
If you completed the cal ride on day one there should be a ride file afterwards. Please post that ride file.
I would do a new cal ride; please post that ride file too.
I would do a new cal ride; please post that ride file too.
John Hamann
Re: Firmware 6.41
Noted.
Will post the file later.
Will post the file later.
Re: Firmware 6.41
Hi,
1. 1st O&B calibration
1. 1st O&B calibration
- Attachments
-
- iBike_10_27_2018_0816_4_km.ibr
- 1st O&B calibration
- (32.44 KiB) Downloaded 141 times
Re: Firmware 6.41
Hi
2. 2nd O&B calibration & ride for 80km
2. 2nd O&B calibration & ride for 80km
- Attachments
-
- iBike_10_28_2018_0649_82_km.ibr
- (495.51 KiB) Downloaded 129 times
Re: Firmware 6.41
I think your wind sensor may be malfunctioning. Please email technicalsupport@velocomp.com for next steps. Please include ride files with your email.
John Hamann