PP on Sensors off
Posted: Tue Sep 18, 2018 7:42 pm
Q: what is the best sequence IF I turn on the PP (push the button on ) but I forgot to wake up the sensor (speed, and/or cadence and/or HR) ?
Do I have to wait x amount of time and start the sequence again?
Do I have to switch the PP off (click button x 5) and start the sequence again?
Can I just wake up the sensors and click the PP button for a second time?
Or just ride and PP will see the awake sensors without further action.
A have a couple of times facing this situation and in one time after re-paring end up activating and O&B calibration (with the old firmware) which I have not seen described in the manual or even in this forum.
-=terry=-
Do I have to wait x amount of time and start the sequence again?
Do I have to switch the PP off (click button x 5) and start the sequence again?
Can I just wake up the sensors and click the PP button for a second time?
Or just ride and PP will see the awake sensors without further action.
A have a couple of times facing this situation and in one time after re-paring end up activating and O&B calibration (with the old firmware) which I have not seen described in the manual or even in this forum.
-=terry=-