PP Advance setup

[speedyvelo]

1. For a calibration ride (not the initial calibration ride) can I load the file and then select part of it? like >select from 5 miles after start to 5 before finish. Of course I am talking of out and back ride. My goal is to do it after the 8 minutes recalibration. Then I would only save the selection and do the recalibration with this select segment of the ride.

2. I have two bicycles with integrated handlebars and a combo mount (bar fly scoop). I know the best is to use profile 2 for the combo mount. Because there is only one profile two, what I did was to use another profile and then change the wind scale to 1.322 so both are the same. Is that correct?

3. Reading the manual says that Crr for smooth concrete should be around 0.004. Is there a list of approximate setup for different surface?
* smooth concrete
* rough concrete
* packed gravel
* loose gravel

4. There are two places to setup the FTP one is under Edit Profile/Basic Tab, the other is under Edit/Setup FTP for a ride. What's the difference?. What is the use of each of those FTP setups?

5. Multiple cost down and recalibration ride Do Not apply to the PowerPod correct?

6. Out of the topic of this thread: Does the new PP with BT allows wireless upload of the files to Issac software?

I love this gadget, you just wake up the garmin sensors and ride. To move it from bicycle to bicycle is very simple. Price is right and Isaac software is excellent.

TIA for your help

-=terry=-