PowerPod problems
Posted: Mon Apr 04, 2016 1:50 pm
Hello,
i bought PowerPod (PP) from USA, it arrived and i installed everything according to instructions. Problem i have is that on my PP i have seen so far only green or red light color (when charging). Cant get it to calibration mode - yellow light. I read some topics, where is written that i should check my GSC-10 if its close enough - i did test, wheel spin inside house and on my garmin 800 i have seen speed and cadence numbers.
If i ride on bike green light stays on for 10s then go off, but watts are shown, but in my opinion they are way too high...
Now i tried to connect it with USB cabel to my computer with Isaac and download newest firmware. But program doesnt find PP, even after i downloaded those silicon drivers, tried everything - push button but still nothing.
I dont know if i doing something wrong or my PP isnt working properly...
i bought PowerPod (PP) from USA, it arrived and i installed everything according to instructions. Problem i have is that on my PP i have seen so far only green or red light color (when charging). Cant get it to calibration mode - yellow light. I read some topics, where is written that i should check my GSC-10 if its close enough - i did test, wheel spin inside house and on my garmin 800 i have seen speed and cadence numbers.
If i ride on bike green light stays on for 10s then go off, but watts are shown, but in my opinion they are way too high...
Now i tried to connect it with USB cabel to my computer with Isaac and download newest firmware. But program doesnt find PP, even after i downloaded those silicon drivers, tried everything - push button but still nothing.
I dont know if i doing something wrong or my PP isnt working properly...