PowerPod V3 - FW10

[luxmoggy]

Hello
Today I upgraded my PowerPod to version 10 of the software. I then did a calibration ride, followed by a short ride.

Here is my ride file. I am riding a FatBike.

Velocomp_2024_06_05_1500_6_km.ibr

(299.12 KiB) Downloaded 133 times

The values all seem good - the wind is from both directions.

But on the PowerStoke screen, there doesn't seem to be any data. My last ride on the old firmware had the PowerStoke data.
That file had "HiDef" in the name. I haven't changed anything else.

Thank you for looking

[Velocomp]

Hello
Today I upgraded my PowerPod to version 10 of the software. I then did a calibration ride, followed by a short ride.

Here is my ride file. I am riding a FatBike.
Velocomp_2024_06_05_1500_6_km.ibr

The values all seem good - the wind is from both directions.

But on the PowerStoke screen, there doesn't seem to be any data. My last ride on the old firmware had the PowerStoke data.
That file had "HiDef" in the name. I haven't changed anything else.

Thank you for looking

PowerStroke is a feature not yet implemented in FW10. If you want PS please email me at jhamann@velocomp.com and I will send you firmware that you can use with Isaac to re-enable PS.