stages pm with newton

Post Reply
ianusy2k2
Posts: 12
Joined: Thu May 07, 2015 11:22 pm

stages pm with newton

Post by ianusy2k2 »

Is stages compatible with Newton?
Velocomp
Velocomp CEO
Posts: 7793
Joined: Fri Jan 11, 2008 8:43 am

Re: stages pm with newton

Post by Velocomp »

Yes; Newton will read Stages power readings
John Hamann
ianusy2k2
Posts: 12
Joined: Thu May 07, 2015 11:22 pm

Re: stages pm with newton

Post by ianusy2k2 »

Doing a scan of Ant sensors will automatically detect the DFPM? How will you know if Newton is showing the DFPM values? I'm trying to switch DFPM display on/off by following the manual
Velocomp
Velocomp CEO
Posts: 7793
Joined: Fri Jan 11, 2008 8:43 am

Re: stages pm with newton

Post by Velocomp »

Yes, doing a Scan of ANT+ sensors will automatically find the Stages (or other) DFPM.

After a Scan, by default the Newton displays the DFPM readings ("On dFP diSP"--DFPM display is on). If you prefer to display the Newton power readings on your screen, then enter Setup (press-hold the center button until "setup" appears). Click the down arrow until "On dFP diSP" appears. Click the center button. "On" flashes. Use the bottom arrow to select flashing "Off dFP diSP". Click the center button to accept' "done" flashes. Press-hold the up arrow to exit setup.
John Hamann
ianusy2k2
Posts: 12
Joined: Thu May 07, 2015 11:22 pm

Re: stages pm with newton

Post by ianusy2k2 »

Thanks for the reply... One last question... Do I need to do calibration again
Velocomp
Velocomp CEO
Posts: 7793
Joined: Fri Jan 11, 2008 8:43 am

Re: stages pm with newton

Post by Velocomp »

No recalibration of your Newton is required.
John Hamann
Post Reply