AeroPod, PowerPod and Newton

Is there a difference between when trying to calibrate the DFPM/Newton+ to do continuous CdA

(DFPM is calibrated and Newton is getting Pin)

1. doing an out and back ride and then doing a "check calibration" in Issac

or

2. starting the cal ride procedure and then doing the prescribed distance cal ride

I find currently if I try to do #2 and then stop or slow for a turn during the outbound portion the newton + thinks I have turned and then begins to read "Bac"...

then I guess there is firmware issue of not being able to get out of the Cal screen without a hard reset...

thanks

James

Please contact technicalsupport@velocomp.com. It's not clear what you are trying to do, and Tom will be able to help you.