Wind cal changed in middle of the ride

Post Reply
still-chasing
Posts: 142
Joined: Sun Mar 28, 2010 5:23 pm

Wind cal changed in middle of the ride

Post by still-chasing »

During my ride today, noticed a sudden change/loss of power about halfway. It's a misty morning. I just let it go hoping the computer will correct itself. About 7 miles before home, I finally can't help it so I stopped and checked the "set up". Wind Cal was VERY HIGH. Blew air in the port to blow out any blockage if any and then click Wind Cal to reset to zero. But every time i click, the number stay high or sometimes negative. I then did a trip reset and did the same. "wind cal" numbers stayed high. I merged the 2 files together.
Thanks!
Attachments
iBike_02_13_2016_0647_53_Miles.ibr
2 files merged
(529.46 KiB) Downloaded 237 times
still-chasing
Posts: 142
Joined: Sun Mar 28, 2010 5:23 pm

Re: Wind cal changed in middle of the ride

Post by still-chasing »

How do I repair the bad file I mentioned above. Thanks!
Velocomp
Velocomp CEO
Posts: 7793
Joined: Fri Jan 11, 2008 8:43 am

Re: Wind cal changed in middle of the ride

Post by Velocomp »

It looks like the mist blocked your wind sensor. If you ride often in these conditions it's time to upgrade to a Newton 6!!

I used the Tools/Repair Selection for Blocked Wind Sensor... command to get your file back to normal. Highlight the bad wind data then apply the command.

Repaired ride file is attached.
Attachments
Screen Shot 2016-02-16 at 5.26.37 PM.png
Screen Shot 2016-02-16 at 5.26.37 PM.png (511.95 KiB) Viewed 3365 times
iBike_repaired_02_13_2016_0647_53_Miles.ibr
(543 KiB) Downloaded 237 times
John Hamann
still-chasing
Posts: 142
Joined: Sun Mar 28, 2010 5:23 pm

Re: Wind cal changed in middle of the ride

Post by still-chasing »

Thank you.
Post Reply