Sensors search for new profile
Posted: Wed Jul 15, 2015 1:09 am
I am trying to setup a new bike (with new sensors) on an unused profile with Newton 5.08. The problem is that Newton would not go and search/find sensors. I tried first without touching the profile, then setting as new profile [in Isaac/Device/Set Up Newton], then by overwriting it with an existing profile, and finally by changing sensor IDs to 0 (using Edit Profiles) and sending it to device.
Even the change to existing profile would not find sensors from that old bike. Other profiles for other bikes work fine.
I tried hard-reset and trip-reset few times. Only once I had "SPCD found" show up (for I have combo), but the message kept flashing every few seconds. In all cases, I cannot get any speed nor cadence to show on Newton. I only get the message "Do Cal", but cannot calibrate it without functioning sensors.
How do I flush the "stubborn" profile? How do I force sensor search in 5.08?
Even the change to existing profile would not find sensors from that old bike. Other profiles for other bikes work fine.
I tried hard-reset and trip-reset few times. Only once I had "SPCD found" show up (for I have combo), but the message kept flashing every few seconds. In all cases, I cannot get any speed nor cadence to show on Newton. I only get the message "Do Cal", but cannot calibrate it without functioning sensors.
How do I flush the "stubborn" profile? How do I force sensor search in 5.08?