AeroPod, PowerPod and Newton

I have the iBike Sport GT and yesterday I had to change out the batteries.

When starting it all back up the unit sensor found the HR monitor and the GSC10 Speed/Cadence sensor not problems and the Garmin Edge 705 reported that it was receiving power data from the iBike. Sweet fuss free and ready to roll, NOT!

The ibike reports Cadence and Heart rate no problem but no speed or power data. I've tried resetting the GSC10 and the ibike and each time it reports that it's found the sensor but again does not report power output or speed.

Can anyone help as I urgently need this unit running for my Pan Japan race and the and training for the Tour Du Japon and Japanese Road Racing Series!

Check and see if you still have a wheel circumference.

Also see if your iBike is reading bike speed. The wheel sensor may be too far from the magnet - since you are seeing the cadence. The gsc-10 arm can slip and the 705 will detect speed from the GPS and never need to know about the wheel magnet.

Tom

The Garmin is reading the speed and cadence no problem, but the iBike is only reading cadence.

One other thing is that I got a new message saying: "PIN FAILED" what does this mean?

Just to let you know it seems to have sorted itself out. Not sure whats goin on here but she's back

PIN suggests you were near another bike with a DFPM and you picked up the address. It is of no concern that this shows up. POUT shows tat you are sending the iBike power values to the Garmin.

Glad the rest of the problem resolved.

Tom