Page 1 of 1
iDash not showing Power readings
Posted: Sun Apr 15, 2012 8:42 pm
by RGA
Hello,
I noticed that while riding today that the power readings are zeroed out but when I upload the file to iBike software it shows power levels at normal range (about 250). The app software I'm using is:
App Software: 1.0.13
Hardware: 2.0.1
Firmware: 1.2.18
iDash+Power
Is there anything I can do to get this working again?
Re: iDash not showing Power readings
Posted: Mon Apr 16, 2012 7:07 am
by Velocomp
Please post your ride file
Re: iDash not showing Power readings
Posted: Mon Apr 16, 2012 11:04 am
by RGA
Attached is a simple 2 mile ride that showed no power output on the iPhone but when imported to iBike software power shows up.
Re: iDash not showing Power readings
Posted: Mon Apr 16, 2012 4:03 pm
by Velocomp
Something seems seriously wrong with your wind readings and your tilt calibration...
Please do another complete bike setup, and retry.
Re: iDash not showing Power readings
Posted: Mon Apr 16, 2012 4:08 pm
by RGA
ok will do and will let you know the results. Thanks for suggestion.
Re: iDash not showing Power readings
Posted: Mon Apr 16, 2012 8:18 pm
by RGA
I did a full setup including tilt and wind zero. Rode out to where I was going to do my calibration ride and my power readings came back. Did the calibration ride and rode back home. I uploaded the ride back home. Seems to be back to normal. Can you check and see if I'm good to go?
Also, Can you explain what you do with the file? Is it something I can learn to do? Would be nice to do the analysis first before I contact y'all for help.