iDash not showing Power readings

[RGA]

Hello,

I noticed that while riding today that the power readings are zeroed out but when I upload the file to iBike software it shows power levels at normal range (about 250). The app software I'm using is:

App Software: 1.0.13
Hardware: 2.0.1
Firmware: 1.2.18
iDash+Power

Is there anything I can do to get this working again?

[Velocomp]

Please post your ride file

[RGA]

Attached is a simple 2 mile ride that showed no power output on the iPhone but when imported to iBike software power shows up.

[Velocomp]

Something seems seriously wrong with your wind readings and your tilt calibration...

Please do another complete bike setup, and retry.

[RGA]

ok will do and will let you know the results. Thanks for suggestion.

[RGA]

I did a full setup including tilt and wind zero. Rode out to where I was going to do my calibration ride and my power readings came back. Did the calibration ride and rode back home. I uploaded the ride back home. Seems to be back to normal. Can you check and see if I'm good to go?

Also, Can you explain what you do with the file? Is it something I can learn to do? Would be nice to do the analysis first before I contact y'all for help.