Isaac SW failed to load

[faheyb]

On updating from version 6.1.2 to Issac 7.1.2 all seemed to be going well until it got to the start to install, where the Installation Summary "to be reviewed" listed "No SW will be installed or removed" and at the bottom of the screen the only options were "Save file, " Back" Cancel - the "Nex"t was grey'd out.

Basically I can not install the Isaac SW and the process has appeared the former SW.

Assistance would be greatly received.

Thanks

[faheyb]

I finally worked it out. I actually do not know why it did not automatically load and run, but on un-installing all remaining and new downloads and starting again - all is good. Now I just need my Newton to arrive and then I will have my hands full in setting up all bikes.

Many Thanks