Lost CAD

[miket5200]

...On yesterdays ride I lost the CAD. Today I couldn't get it to find the CAD. So I replaced the battery in the sensor and still didn't work. I can wave a magnet by the sensor and hear a clicking sound but it still says "CAD not found".

Also for some odd reason I'll just get the "wireless fail" message.

Any suggestions on what to check or do?
Cheers,
Mike

[Site_Admin]

Mike - you'll need to do a re-pairing. Go into "Setup", "wireless Config", and then switch 'cadence' back to 'find'. Then get out of setup, press the center button, and start rubbing the magnet across the sensor. If it still fails, try another battery flip, and re-attempt the rub. If you still have no luck, call me.

[miket5200]

...In the set up menu it said that the CAD was paired. But it still couldn't find it. So I went thru the steps for pairing the CAD... did the battery flip etc. and still "failed" I did this twice the first time it came back saying "wireless fail"

What's next?
Mike

[Site_Admin]

Send a note to me via this board, or e-mail me or call off-list. We'll either solve it, resolve it, or replace it.

[miket5200]

...I tried everything. Should I just send it back. I'm getting pretty frustrated.
Cheers,
Mike