no power readings in trainer setting
Posted: Fri Mar 16, 2012 10:59 pm
My trainer settings have worked fine until this week. When I woke up the ibike it was in the trainer off mode, so I turned it on and then reset the log, which has worked in the past. This time, it didn't and I kept getting 0 power readings. Today, I started it up and it recognized my sensors (hr, cad and speed) and said it was in the trainer on mode. However, when I started pedaling, it then said 'trainer off' and the power readings went back to 0. When I tried to set it through the user sequence, it showed that the trainer was already set to on.
On another note, sometimes when I wake up my ibike, it doesn't go through the normal start-up procedures, such as showing the battery level, wind calibration, etc. and then it won't recognize all of my sensors. Any thoughts on this?
On another note, sometimes when I wake up my ibike, it doesn't go through the normal start-up procedures, such as showing the battery level, wind calibration, etc. and then it won't recognize all of my sensors. Any thoughts on this?