Page 1 of 1
New Setup
Posted: Fri Apr 12, 2013 1:50 am
by dgf
Went with new bar set up and just no way the Newton was going to see clean air without using RWS. Did some pondering and came up with this setup:
Seems decently clean, simple, should see good air. Will try Cal Ride tomorrow.
Re: New Setup
Posted: Fri Apr 12, 2013 7:26 am
by Velocomp
Looks good! Please post a ride file!
Re: New Setup
Posted: Fri Apr 12, 2013 8:20 pm
by dgf
Seems like it works OK. Maybe a little windy for a Cal Ride but data looks OK to me...??? Attached Cal Ride and little loop I did a couple times.
Used two of these for the set up - pretty simple:
http://www.amazon.com/Profile-Design-Un ... uter+mount
Re: New Setup
Posted: Fri May 10, 2013 5:29 am
by Velocomp
Your cal ride looks great but your 13 mile ride is odd, for two reasons:
1) your CdA is different from your Cal Ride, and is set to road-bike value. Did you change it? If so, why
2) It looks like you have strong tail winds in part of your ride. Is this correct?
