iAero goes to "scan" mode instead of setup
Posted: Mon Apr 18, 2011 7:58 pm
This happened twice last weekend at very inopportune times: I'm riding around for awhile (20 - 40 minutes), stop, then I hold the "up" arrow to go into setup. Instead of going into setup, the iAero goes straight to "scan yes" to look for devices. Why would it do this?
* new battery in iAero
* different wireless mounts, so it's not the mount (one was road, the other tt bike)
* both bikes had DFPM (SRMs)
as for the very inopportune timing: I was looking to do the SRM offset at a time trial start the first time. The second was waiting at the start line of a crit, again wanting to do an offset calibration before the race. ugh.
* new battery in iAero
* different wireless mounts, so it's not the mount (one was road, the other tt bike)
* both bikes had DFPM (SRMs)
as for the very inopportune timing: I was looking to do the SRM offset at a time trial start the first time. The second was waiting at the start line of a crit, again wanting to do an offset calibration before the race. ugh.