AeroPod, PowerPod and Newton

Frustrated, I am.

It has been difficult, or impossible to download EVERY ride of over 60 miles I've done since up-grading to fw4.

While it is sometimes possible to get the ride downloaded, it involves clicking past a screen that mentions this undefined error code 6004--and then as often as not there is another screen stating that labview's memory has been exceeded.

This needs attention.

I also get this error code in a slightly different circumstance. I have recently upgraded from Gen II to Gen III i-aero and when trying to download calibration rides and coast downs it gives me this message in a popup window, and it says that no profile is recognized. I've installed/uninstalled the software on my computer now and done a hard reset of the i-bike unit, but still get the same message.

1) How do I fix this?
2) Even if I haven't been able to fine tune and set the profile on the ibike 3 software because of this issue, is my unit calibrated on the bike if I've done cal ride and coast downs?

Thanks in advance for any help.

We are investigating.

One of our customers has reported that uninstalling and then reinstalling iBike 3 fixed this problem.

Also, please make sure you have iBike 3.05 installed. Go to Help/About iBike 3 to check your version.

We will be releasing iBike 3.06 soon. This new SW eliminates this problem and, of course, adds a few new cool features!