Page 1 of 1
Trainer unlock for Gen3 upgrade
Posted: Sat May 09, 2009 6:44 am
by wazza15
When I upgraded from Gen1 to Gen3, I assumed that my trainer feature I already paid for once with my Gen1 would carry over to my new Gen3 - but apparently not! Is it the case that one has to pay for the trainer unlock all over again?(!) If so, this would seem fairly punitive for a very small bit of code... Can anyone give me advice on this, please.
Re: Trainer unlock for Gen3 upgrade
Posted: Sat May 09, 2009 12:28 pm
by Russ
wazza15,
I am sure if you email John Hamann that he will straighten you out.
use jhamann <at> velocomp.com but replace <at> with @ (protection against spam email address harvesters).
Russ
Re: Trainer unlock for Gen3 upgrade
Posted: Sat May 09, 2009 1:23 pm
by R Mc
The trainer feature already IS unlocked with firmware 3.09 for Gen3. You might be getting problems trying to upload a different key, though.
Re: Trainer unlock for Gen3 upgrade
Posted: Sun May 10, 2009 6:34 am
by Velocomp
If you upgraded to a Gen III iPro then your trainer key needs to be unlocked. email me and I will get you going.