iAero shutting off while waiting for race start
Posted: Sun Oct 30, 2011 3:30 am
I have been using an iAero for 15 months and successfully use it on 4 bikes, including a TT bike and a MTB. I find that I need to run a scan every time I change bikes, but it will recognise the sensors if used on the same bike in sucession. I assume that this is normal.
Recently I have an issue with the iAero turning itself off while waiting for a race start - It did not do this earlier - has a recent software change caused this? I generally have a good warmup, with the iBike all set up and running, and then wait for the race start, with the Speed and Cadence sensor obvoiusly not detecting signals, but with the HR sensor continuing to read - the iBike just times out and shuts off. I am not able to then get it going , it looses everything and I need to go and re-sacn. THIS IS NOT REALLY ACCEPTABLE in this type of situation.
Is there a simple way of inhibiting the "timeout" while the HR is running, or is there an easy way to re-set, without leaving the race start area.
I would appreciate feedback on this.
thanks
Recently I have an issue with the iAero turning itself off while waiting for a race start - It did not do this earlier - has a recent software change caused this? I generally have a good warmup, with the iBike all set up and running, and then wait for the race start, with the Speed and Cadence sensor obvoiusly not detecting signals, but with the HR sensor continuing to read - the iBike just times out and shuts off. I am not able to then get it going , it looses everything and I need to go and re-sacn. THIS IS NOT REALLY ACCEPTABLE in this type of situation.
Is there a simple way of inhibiting the "timeout" while the HR is running, or is there an easy way to re-set, without leaving the race start area.
I would appreciate feedback on this.
thanks