I got some water into the cadence sensor last time I washed my bike. Now I cannot get the sensor to work properly. I've tried a new battery, drying it with a hair dryer (on low), and repositioning. Nothing works.
Any solutions or do I need to purchase another sensor?
Thanks, Greg
Water in cadence sensor == Cad Fail
- lorduintah
- Posts: 642
- Joined: Fri Jan 11, 2008 9:37 am
- Location: Plymouth, MN
Re: Water in cadence sensor == Cad Fail
Before you buy a new one - try a battery reset - put the battery in with the wrong polarity for a couple seconds - then take it out and put it in with the right polarity. It might reset the circuits - it will change the address - so you may have to rescan for it.
Tom
Tom
Re: Water in cadence sensor == Cad Fail
Tom,
Thanks for the suggestion. I went out and tried your suggestion but the sensor still seems dead.
Greg
Thanks for the suggestion. I went out and tried your suggestion but the sensor still seems dead.
Greg
-
- Site Admin
- Posts: 392
- Joined: Fri Jan 11, 2008 8:52 am
- Location: Durham, NC
Re: Water in cadence sensor == Cad Fail
Ever since my 13 year old sent his iPod through the wash, I've started saving the little desiccant bags that come in consumer electronics boxes. I read stories of others in my situation who have been able to recover Nanos by putting them in desiccant in a warm place for 24 hours, but alas, it didn't work for me. Instant rice is also acts as a desiccant--just don't confuse the rice and silica gel.
Travis
Travis