Calibration failed powerpod v3
Posted: Sat Jan 22, 2022 6:26 am
I just bought a powerpod v3. Was very excited.
I updated firmware, setup the powerpod and did like 10 calibration rides.
Always same result. After the power went up to 100 I get blinking red light. This means the calibration ride failed.
So tried different bike with different wahoo sensors. Did a hard reset and started the process again. Same result.
This is frustrating.
In this forum los_leo had the same problem but there was no answer bto his problem
I updated firmware, setup the powerpod and did like 10 calibration rides.
Always same result. After the power went up to 100 I get blinking red light. This means the calibration ride failed.
So tried different bike with different wahoo sensors. Did a hard reset and started the process again. Same result.
This is frustrating.
In this forum los_leo had the same problem but there was no answer bto his problem