Search found 186 matches
- Sat Jun 13, 2009 12:02 pm
- Forum: General Discussion
- Topic: Battery test & battery life?
- Replies: 6
- Views: 4448
Re: Battery test & battery life?
Cool, I can just keep a spare battery in by pack then. Thanks for the info!
- Sat Jun 13, 2009 6:50 am
- Forum: General Discussion
- Topic: Battery test & battery life?
- Replies: 6
- Views: 4448
Re: Battery test & battery life?
How many hours of riding should one expect to get out of a battery? I do understand that the unit will tell me when the battery is bad. But my question really is more about how to avoid the situation where one starts out with a good battery test, but the battery runs down and goes bad during the rid...
- Fri Jun 12, 2009 7:27 pm
- Forum: General Discussion
- Topic: Battery test & battery life?
- Replies: 6
- Views: 4448
Battery test & battery life?
When I put a fresh one battery, I can watch the voltage drop on the battery display in setup (I have a Gen III with 3.09 FW). It does start over 300, but then very slowly drops about 1 every minute or so. Clearly it doesn't continue at this rate, is appears to slow down as the number drops. Ultimate...
- Mon May 04, 2009 5:32 pm
- Forum: Wireless Troubleshooting
- Topic: cadence sensor sleeps too soon
- Replies: 1
- Views: 2681
cadence sensor sleeps too soon
When I stop my ride for a few minutes, I notice that my cadence sensor goes to sleep in a rather short period of time, maybe 5 minutes. The speed sensor stays awake just fine.
I know I can wake it up just fine, but it is a little annoying...
Any adjustment?
I know I can wake it up just fine, but it is a little annoying...
Any adjustment?
- Fri Sep 19, 2008 7:57 am
- Forum: Frequently Asked Questions
- Topic: Unable to get good tilt calibration
- Replies: 2
- Views: 2745
Re: Unable to get good tilt calibration
I did a "wall" tests (holding it up againt a wall right-side up the up-side down).
I see 87.7 and -12 (approx)
But to directly answer your question I cannot get it to display anything higher than 87.6 or 87.7
I see 87.7 and -12 (approx)
But to directly answer your question I cannot get it to display anything higher than 87.6 or 87.7
- Thu Sep 18, 2008 9:47 pm
- Forum: Frequently Asked Questions
- Topic: Unable to get good tilt calibration
- Replies: 2
- Views: 2745
Unable to get good tilt calibration
I have tried this perhaps 10 times with no luck. I have been very careful each time, and get the same results. When I do my validation of the tilt I am seeing -0.7 in one direction, and -0.2 in the other. This of course is beyond the recommended 0.2 differentiation I need for a successful tilt calib...