AeroPod, PowerPod and Newton

Just a hint, make sure your power field ISN’T an average field.... I had mine set to 5s average and wondered what was going on

Excellent can’t wait to get home from work now

Is the pitot tube necessary for just running as power meter? I don’t have my dual side crank pm yet.. so no need for cda.

Does anyone know how to check this on the wahoo bolt?

not sure it matters but I realise I actually have the Garmin 520

Awsome

Hi Team,

Is there anyway of sending the battery charge status to a head unit? EG Garmin 510

Dave

Hi Newbie question,

Could I get some help checking the calibration of my new power pod, I set up using the set-up newton function, I was seeing some really high wattage readings. There was some wind on the ride but I of not feel that I was hitting peaks of 500+W.

thanks for that

This is the last ride i have done on my road bike

I have just purchased a new wheelset and have switched to 700x25, and i have not had great experience calibrating my GEN III. I believe that the power is reading high on my current wheelset, comparing with my jetblack power trainer and the spin bikes at the gym. The power reading that i get on the r...

Hi All, I have a GEN III wireless pro and i have been using on my roadbike with no issues for a couple of years, and i am having some issues calibrating to my MTB, it doesnt have lockable forks, so i am having troubles with the Cal ride, coast downs and some of my rides are stating that they have a ...

Thanks Richard, will try another cal ride. I tweaked the CRR to 0.0050 and the wattage returned to what about what i expected.

Common issue I know but i have just moved my iBike Pro to my second bike and with a new speed/cadence sensor. I did a cal ride this morning and a 30km ride straight after, i havent done the coastdowns as there was too much traffic around. I found that for most of the ride, except when the iBike show...

thanks a bunch

Any chance of getting JetBlack Z1 Fluid Trainer added, i have looked on their site and i have only been able to find the image on the attached link

http://jetblackcycling.com/aus/products ... -trainers/

- Temps range from 15 degC to 28 degC - i bought the unit in June 2010 - 1 sec recording I will replace the batteries, check both voltages, wireless and head, and see what they are at the end of the ride, and then again when i ride again. What i am seeing is that they are usually fine for one ride b...

I have owned the Ipro now for 6 months and have had to replace the batteries nearly every ride, in the head unit and wireless unit. i have used "name" brand batteries and have checked with multi meter, and they are running at ~3.05V when i put them in, but when i go to turn on the unit the...

I have managed to get the calibration done and have done 10 cost downs, numbers seem to fit better. I checked the wind sensor and there was nothing stuck in there, i got some Air in a can and gave it a clean, Last nights ride showed wind reading that seemed more realistic, and it was the first ride ...

Thanks for the reply, 2 things
- how do i get the wind sensor readings?
- i bought this from a bike store in june this year....

Dave

no response?

sorry for the delay, have been realy busy with work. I have uploaded a 20km ride and one of the calibration rides

I have updated the firmware and have done a hardware reset on my new iPro wireless, so i went to do a calibration ride, and after i got back, i got calibration fail message. I tried 3 times over the same course, one after each other and i got the same result, i re-did the tilt and wind offset, both ...