AeroPod, PowerPod and Newton

Thanks for the information! I looked through the manual and did not see any instructions on how to do this.

How do I zero torque on a powertap g3 hub using the iBike Newton? I have searched the forum but did not find any instructions on how to do this with the Newton. Any help would be greatly appreciated.

Thanks!

Thanks for all the great ideas! Your input is truly appreciated.

John

Thanks for the ideas. I am hesitant about putting super glue on an expensive carbon fiber wheel but using rubber cement sounds like a good alternative. I have some rare earth magnets and I am hoping that they are going to allow more "wiggle room" as far as the placement of the receiver. Th...

I have a rear disc wheel that I use in TTs and would like to know how I can attach a magnet to it so I can use my new Newton for TT races. Any help or suggestions would be greatly appreciated.

Thanks!

I have an old wired mount and would like to know what else I need to have the new Newton work on my current setup. I am guessing that I will need some sort of wireless sensor that will transmit the data to the Newton. Is that correct? If so, could you tell which sensor package I need?

Thanks!

I couldn't do more than three attachments so here is my profile.

I have also started to have problems with the wind calibration recently on my Gen III ibike. I upgraded to a Gen III in August and it was giving me credible readings until the past two or three weeks. During a ride the unit will start reading either a massive headwind or tailwind. I have attached a ...

I did a profile for a new TT bike and I wanted to know if the numbers are acceptable. Aero .570 Wind Scaling 2.361 CdA .241 Fric 6.532 Riding Tilt -.4 Crr .0044 Cal Weight 174 I was not wearing my TT helmet, wheels, or skin suit since I wanted to use this profile for training. Any comment would be g...

As always, I would like to express my gratitude to people responding to my post. To answer Racerfern's question, this is not exactly an out and back ride. I rode to a location where I do some hill intervals on a particular hill but I did not take the exact route back home as I did to the hill. To an...

Here is a screenshot of the profile I used. Any help or comments would be greatly appreciated.

Thanks!

John

Here is a screen shot of the tilt & power page.

Are there universal signs that might indicate that you have a bad profile? The reason I ask is the discrepancy between avg. watts after I do detailed analysis. The "raw" data indicates I am averaging 236 watts during an interval, where the post analysis indicates I am averaging 221 watts. ...

My riding tilt % from the profile is -0.173 and from what you said it sounds like this could be good data. I have the Ibike unit mounted beneath the TT bars so it can get a good shot at "clean" air. Concerning coast-downs, if I did future wind offsets and tilt calibrations in a controlled ...

Thanks for the reply Fernando! Before the correction the green line in the advanced sreen is sloping downward at around a 30 degree angle. To correct this problem should I do a tilt calibration or do I need to re-do the coast downs and 4 mile ride also?

I did an individual TT in Philly today and I am not sure about the data that I got. The "raw" data said that my avg. watts were 247, the Auto analyze 307 and the Analyze Tilt/Power 338! Which one is the most accurate? Any coments, suggestions or help would be greatly appreciated.