AeroPod, PowerPod and Newton

Just for reference, the url that is called when getting the GPS data is:

ibike.dyndns.biz on port 7444.

I had to provide an allow rule on both my home firewall and my DNS provider (NextDNS).

No problem John, I'll figure it out.

Thanks for your support

Hi John, I have figured out that the issue is something to do with my over engineered home network. Using my phone as an access point, I can login to tracker and get a confirmation, after that I can download the GPS data. Now I just need to figure out what is being blocked from my end. Is there a sp...

Hi John, I managed to get out for a short ride today. I ran Velocomp Tracker on my phone from the start to the end and uploaded afterwards - see: TrackerConfirmation.png After connecting my PowerPod to my Mac and downloading the ride file, I open the ride I just completed and select (from the burger...

Hi John, Thanks for the prompt response, I note that the interface with the correct credentials appears to 'login', but there is no confirmation of success. However, if I provide a bad password then, I do see a response stating that there is a problem. So, it appears that I am logged in. I think I n...

Hi, I recently moved over to Mac OS, so have installed and have Velocomp Aero for Mac working. However, if I try to login with my Velocomp tracker credentials (Device -> Login to Velocomp tracker..), the interface simply does not respond when I click 'login'. Is this a known issue, or am I being daf...

Hi John,

Thanks again for the reply.

All clear now, I will make sure I have good copies of my exports for the next time I need to do a reset (a rare occurrence).

Regards,

Jon

Hi John, Thanks for the reply. For item 1. I mean that I've used Isaac to preform the factory reset: Device -> Setup -> Reset profile/ device -> Complete device reset For item 2, where I have previously exported the profile from the device after doing a calibration ride, then once the device reset i...

Hi, Context: I have a PowerPod v3, that I've been using for a few years on my gravel bike. During use I've had a few instances where I've needed to do a factory reset of the PowerPod to resolve issues and each time I've had to go through the setup process/ calibration etc. Question: I have used the ...

Thanks John,

That worked, I was not seeing the new device ID (get from device) before, but it is showing now.

Is it necessary to perform a new calibration ride to take the new HRM into account? Nothing else has been changed.

Many thanks,

Jon

Hi, I've been using a PowerPod v3 for the last couple of years, I initially set it up with a set of Garmin sensors (non magnet) and Garmin HRM. All has been OK. This week my Garmin HRM has been acting up, so I thought I'd simply swap to a newer Wahoo Tickr HRM. However, I can't figure out how I can ...