Search found 42 matches

by Wobblydrow
Sun Feb 25, 2024 4:43 am
Forum: PowerPod
Topic: Gravel question
Replies: 0
Views: 364

Gravel question

Hi i just set up PP V3 for my gravel bike rather than previous road bikes where was working well and has some questions. I did the cal ride and updated weight etc, and on the ride gave numbers that were sensible, if a little low. When i downloaded and analysed it said CRR was 0.017 vs what is recomm...
by Wobblydrow
Wed Dec 29, 2021 8:00 pm
Forum: PowerPod
Topic: Wind and slope stop reporting but power ok
Replies: 3
Views: 1603

Re: Wind and slope stop reporting but power ok

When i downloaded the files for the ride into Isaac, it appears that as i stopped the PP to save battery life during the ride, it saved all the rides as seperate files, however, my garmin only recorded the power once the second part of the ride commenced. This is interesting as the wind on the garmi...
by Wobblydrow
Mon Dec 27, 2021 3:34 am
Forum: PowerPod
Topic: Wind and slope stop reporting but power ok
Replies: 3
Views: 1603

Wind and slope stop reporting but power ok

Just did a big 250km ride, after 60km we stopped for coffee and I turned my PP and garmin off. After I reconnected and power was ok, but after ride, wind and slope were a flat line, any ideas why that might be
by Wobblydrow
Sun Oct 24, 2021 5:36 am
Forum: PowerPod
Topic: calibration screen
Replies: 1
Views: 1505

calibration screen

Hi I have asked before but never really got a good answer. The instructions for calibration says the out will stop and hold at 50 count until come to a stop and then start on the back leg to 100, however, my PP3 never does this, it will continue past 50, and due to the 3-6 second delay will often re...
by Wobblydrow
Sun Oct 25, 2020 3:36 am
Forum: PowerPod
Topic: Powerpod V3 causing drops in estimated cadence
Replies: 78
Views: 30152

Re: Powerpod V3 causing drops in estimated cadence

FWIW I have the same issue but I have a wahoo cadence sensor and Garmin 530 and PP3 . I have another bike / profile with Garmin sensors and no dropouts. Exhibits the same behaviour as previously described, intermittent reducing in cadence for a few seconds to low 60.
by Wobblydrow
Wed Feb 05, 2020 3:06 am
Forum: PowerPod
Topic: Adding hr sensor at a later date
Replies: 3
Views: 2586

Re: Adding hr sensor at a later date

I know my HR sensor ID, but on a recalibtration it didnt get picked up. How do i activate the HR strap when "wireless enabled" green check button cannot be activated by clicking on it, its not a on/off button but just an information button, so i can add the HR ID into the text boxes, but c...
by Wobblydrow
Wed Feb 05, 2020 2:59 am
Forum: PowerPod
Topic: PPv3 suddenly went out (battery ok)
Replies: 9
Views: 4108

Re: PPv3 suddenly went out (battery ok)

Of interest I have had exactly the same happen twice - hard reset fixes it.

Perhaps for the tech team, i noticed that at the exact time my cadence sensor went to zero rpm and stayed zero, (all on ANT+) so something must be going wrong with the communication protocol somewhere
by Wobblydrow
Sat Jan 25, 2020 6:48 pm
Forum: PowerPod
Topic: New cal ride
Replies: 7
Views: 4108

Re: New cal ride

One bike was 1.05 and the other 1.3 wind scale, associated aero/friction the same proportional difference. . Everything else the same (both road bike of similar weight, 25mm tyres at same pressure etc)
by Wobblydrow
Fri Jan 24, 2020 3:29 pm
Forum: PowerPod
Topic: New cal ride
Replies: 7
Views: 4108

Re: New cal ride

Interesting, I have 2 bikes both with minus 0.7 degree tilt yet different aero/friction value (with some crr etc.), so must have another variable in how it's calculated. I guess my ultimate aim was to understand what calibration actually does relative to the numbers produced and understand for compa...
by Wobblydrow
Fri Jan 24, 2020 4:42 am
Forum: PowerPod
Topic: New cal ride
Replies: 7
Views: 4108

Re: New cal ride

Thanks John tech support assisted and fixed the issue, they said after sensor pairing to ride for 10-15s to get red/green flash, not press the button to get yellow light and then red/green as per what the instructions say. Once did that everything worked. If i have two road bikes of the same Crr, th...
by Wobblydrow
Thu Jan 16, 2020 8:55 pm
Forum: PowerPod
Topic: New cal ride
Replies: 7
Views: 4108

New cal ride

Hi I have changed my PP location so wanted to do a new set of cal rides across my three bikes so deleted profiles by reset unit in Isaac. Set up first bike, cal ride worked well. Downloaded details and then set second bike as active profile, but as I have seen in the past the cal ride didn't go the ...
by Wobblydrow
Tue Dec 31, 2019 5:56 am
Forum: PowerPod
Topic: Calibration effect
Replies: 3
Views: 2153

Re: Calibration effect

Thanks for the information If I have 3 profiles for seperate bikes (all mounted in same position on handlebars) are the following set of numbers acceptable as aero/windscale/friction/tilt, or should I be recalibrating any? Is their a specific numerical equation that when these numbers are inputted s...
by Wobblydrow
Sun Dec 29, 2019 5:39 am
Forum: PowerPod
Topic: power average vs NP
Replies: 3
Views: 2376

power average vs NP

Hi When i look at a downloaded file my average power differs to the file my Garmin uploads. I was wondering does the isaac software include or exclude zero power time in the average calculation. my NP values are far closer, only a few watts difference, but aerage power can be 20% off. Secondly, uplo...
by Wobblydrow
Sun Dec 29, 2019 5:08 am
Forum: PowerPod
Topic: Calibration effect
Replies: 3
Views: 2153

Calibration effect

Hi After reading nearly every article in the forum and a lot of your assistance, could you explain what calibration actually does in real terms, given the PP is continually rechecking the mounting angle every 90 seconds? If this is true, and the accelerometer is accurate, what purpose does a calibra...
by Wobblydrow
Sat Dec 28, 2019 2:54 am
Forum: PowerPod
Topic: CDa estimate
Replies: 4
Views: 2443

Re: CDa estimate

Thanks for explaining.
by Wobblydrow
Fri Dec 27, 2019 6:27 am
Forum: PowerPod
Topic: CDa estimate
Replies: 4
Views: 2443

Re: CDa estimate

Apologies. Let me clarify. If the app calculates my cda at a value 0.032 for the parameters input, what variability could it really be i.e. would it be 0.032 +/- a fraction, , or could it be a wide range and the value given is just a best guess. My question really is how much error can be present in...
by Wobblydrow
Wed Dec 25, 2019 10:45 pm
Forum: PowerPod
Topic: CDa estimate
Replies: 4
Views: 2443

CDa estimate

Hi How much variation can you expect with the CDa estimation value vs what real world may be...if you add your height/weight/riding position what is the likely range of value in the real world vs the 0.032 the software estimates (for my size), can it have a significant effect or is it unusual that i...
by Wobblydrow
Sun Oct 27, 2019 10:13 pm
Forum: PowerPod
Topic: What does calibration set
Replies: 1
Views: 1441

What does calibration set

Hi When you do a cal ride, is this only to establish the wind scaling and angle, does a calibration modify any settings not visible in the profile section? When we do a check calibration is this just modifying those data field just on the basis of a longer distance and therefore more accurate data c...
by Wobblydrow
Sat Oct 05, 2019 6:54 am
Forum: PowerPod
Topic: When to adjust ride data?
Replies: 5
Views: 2522

Re: When to adjust ride data?

Thanks The ride differences are due to where i started / stopped...the wheels on both bikes are both identical circumference, to within 1mm, both same brand 25mm tyres at same pressure. Do you see anything with the setup / data that suggests a difference is calibration related, as all the rides i do...
by Wobblydrow
Thu Oct 03, 2019 3:27 am
Forum: PowerPod
Topic: When to adjust ride data?
Replies: 5
Views: 2522

Re: When to adjust ride data?

2. i meant the "wind changed" check box in analyse ride 3. I have attached three ride files from last three days. Bike 1 is the bike i believe is giving hirer power, but has been calibrated twice and the check calibration give nearly identical numbers Bike 2 ride 1 and two are the other bi...
by Wobblydrow
Wed Oct 02, 2019 4:48 am
Forum: PowerPod
Topic: No power reading on edge 820
Replies: 14
Views: 6264

Re: No power reading on edge 820

Apologies for the late reply. I see dashes not zeroes. As per previous post i have made on this one, perhaps one ride in 10 the values appear, no matter which order i turn the units on

BTW any chance you will put a version out for regular PP that just has slope and wind on?
by Wobblydrow
Wed Oct 02, 2019 4:46 am
Forum: PowerPod
Topic: When to adjust ride data?
Replies: 5
Views: 2522

When to adjust ride data?

Finally have my PP v3 working across 3 bikes consistently. Just a couple of final questions 1. Under what conditions should the "analyse route be used" after a ride is downloaded. i tend to find about 10% reduction in average and normalised power after using the analysis....should i really...
by Wobblydrow
Tue Sep 10, 2019 6:54 am
Forum: PowerPod
Topic: Elevation / pressure
Replies: 1
Views: 1381

Elevation / pressure

I know elevation isn't important, its the relative change that is, but will this affect the total power calculated if i ride in the morning and then later in the day home when the weather is different?, and i join the two files together in the software(so i can upload to strava as one ride)? Current...
by Wobblydrow
Tue Sep 10, 2019 6:40 am
Forum: PowerPod
Topic: No power reading on edge 820
Replies: 14
Views: 6264

Re: No power reading on edge 820

I have a Garmin 530 bluetooth connection PP v3 to Garmin at same time as garmin to phone, no problems. Sensors connected over ANT. My problem is the CDA screen sometimes gives a reading and sometimes, no matter how many times i reboot, comes up with zeros on every field....never had a power problem ...
by Wobblydrow
Mon Aug 26, 2019 4:23 am
Forum: PowerPod
Topic: Cal ride vs 4 second reset
Replies: 0
Views: 4654

Cal ride vs 4 second reset

As i have been having a few problems with my various bike setups I decided to do a hard reset and start again. I set a profile in Isaac from start of process and uploaded, first bike went well, a ride with _calride_ in title appeared. Transferred to a second bike and the cal ride started as normal, ...
by Wobblydrow
Thu Aug 22, 2019 3:51 am
Forum: PowerPod
Topic: Unstable ride
Replies: 3
Views: 1977

Re: Unstable ride

Ok so PP locked in and now unmovable I did two rides on two bikes back to back, I wanted to check if now being ultratight locked was going to change numbers i have seen, I rode an identical course on both bikes out and back. Both profiles previously had a 5km ride used as a calibration base. Today, ...
by Wobblydrow
Sun Aug 18, 2019 11:13 pm
Forum: PowerPod
Topic: PowerPod V3 transmits slope and wind too!
Replies: 6
Views: 4025

Re: PowerPod V3 transmits slope and wind too!

I still can't get this to display except directly after a cal ride (on garmin 530). I have tried rebooting multiple times after first connecting to powerpod, change from Bluetooth the Ant connection and back again, none of which works.

Any ideas where to go next?
by Wobblydrow
Fri Aug 16, 2019 9:19 pm
Forum: PowerPod
Topic: Unstable ride
Replies: 3
Views: 1977

Unstable ride

Hi Just as I thought i was getting settles with my powerpod I had a terrible experience today. Started off on a bike and paired sensr first, no issue, then garmin, but still the slop / cda not showing on the garmin even after reboot I thought that the numbers looked bad on the ride to start with, wa...
by Wobblydrow
Fri Aug 16, 2019 9:18 pm
Forum: PowerPod
Topic: Unstable ride
Replies: 1
Views: 1218

Unstable ride

Hi Just as I thought i was getting settles with my powerpod I had a terrible experience today. Started off on a bike and paired sensr first, no issue, then garmin, but still the slop / cda not showing on the garmin even after reboot I thought that the numbers looked bad on the ride to start with, wa...
by Wobblydrow
Thu Aug 15, 2019 6:50 am
Forum: PowerPod
Topic: Multibike & "best" cal
Replies: 8
Views: 3527

Re: Multibike & "best" cal

Thanks - i did pair the powerpod before turning on garmin. I will try again if happens again. thanks