How important is the location where one does the calibration ride? Does the route need to be flat(ish) with no traffic?
Can I just ride around our large(ish) parking lot?
Question about calibration ride?
Re: Question about calibration ride?
If your calibration route has a lot of sharp turns, such as you might have in a parking lot, that is not good.
I have a 1.1 mile loop where I do calibrations. Gentle turns. That is fine.
I have a 1.1 mile loop where I do calibrations. Gentle turns. That is fine.
John Hamann
-
- Posts: 186
- Joined: Thu Sep 18, 2008 9:42 pm
Re: Question about calibration ride?
k, thanks!
-
- Posts: 186
- Joined: Thu Sep 18, 2008 9:42 pm
Re: Question about calibration ride?
I got a little confused during the initial setup.
If I select "Better Accuracy" it says that I can just go ride. But When I initially paired my speed sensor to the device it appeared to need a calibration?
If I select "Better Accuracy" it says that I can just go ride. But When I initially paired my speed sensor to the device it appeared to need a calibration?
Re: Question about calibration ride?
In AeroPod, a "Best Accuracy" calibration is initiated, no matter what is selected in Isaac.
Also, a calibration ride is forced whenever a sensor pairing is done.
These items are covered in the instructions.
Also, a calibration ride is forced whenever a sensor pairing is done.
These items are covered in the instructions.
John Hamann